Carpet Mills/Mill Plans

[slim12]

http://www.apbt.online-pedigrees.com...&myPedigrees=1

Carpet mill for sale. $300. Located in NC. Free-spinning, very smooth and very quiet. One hand pull will result in two-plus rotations. Pick up only.
Very soon I will have plans/blueprints to build your own mill for less than $150, actually closer to $125. For $60 I will provide a picture-filled set of directions, a material list and the material availbility. I will also provide the two end rollers already assembled and ready to slide into place. The end rollers are sort of difficult to build (and your cost would triple by the time you bought a 6" hole-saw and a brad nail gun and air compressor). The end rollers will be assembled with the correct height spacers already installed. Anyone interested in the set of plans? Drop me a line here or at

***No emails allowed in open forum's, use PMs please*** Edited by Marty

[Buck E. Owens]

Can't see ped!

[Calidude]

If the plans and rollers are still available I'm interested pm me thanks